HM Digital PS-200 Commercial Dual Inline TDS Controller

  • Model: PS-200
  • Shipping Weight: 1kilos
  • Manufactured by: HM Digital

 0 avg by 0 reviews

Online Only Special
$50.00  (14%) off RRP

More Images: (1)

Install the Dual TDS Controller to constantly monitor TDS levels of water produced by a high-output system. Immediately know if the TDS levels rise above an acceptable level.
- Monitors and controls TDS levels of two water lines (e.g., feed water and product water) for high output commercial systems.
- Large, bright L.E.D. display.
- An alarm will sound if the TDS level rises above the user-set level for the output water.
- Installs easily in minutes.
- Includes two sensor probes (at no extra cost).
- The PS-200 is a monitor for Line 1 (in-line) and a controller for Line 2 (out-line).
- Range: 0 - 999ppm 
- Accuracy: +-2%
- Conversion Factor: NaCl (avg. 0.5)
- Resolution: 1 PPM 
- ATC: Yes (1 - 65 degrees Celsius) 
- Calibration: Adjustable 
- Setting: Controlled by on-screen up/down buttons 
- Relay Control: The unit will open or close a circuit via dry contacts when the ppm level (out line/line 2 only)reaches or exceeds the control setting (simple switch).  It can be used to control a pump, solenoid valve or other device. (In line/Line 1 does not have a control function) 
- Relay Voltage: 5V (simple switch)
- Alarm: Optional steady beep for Out line/Line 2 (set by user)
- Display: Bright 5/8" L.E.D. display 
- 2 Probes: 1/2" bushing (NPT), 3 meter (9.8 ft) shielded cable 
- Power supply: AC 110V / AC 220V 
- Dimensions: 7.2 x 7.2 x 10.2 cm (2.8 x 2.8 x 4 in.)
- Monitor Weight: 476 g (1 lb .8 oz) ?- Total Weight: 822.1 g (1 lb 13 oz)

There are no compatible products available.

There are no also purchased products available.

There are no reviews on your listing!

Subscribe to our newsletter to get latest news about water filters